Kroon Professional Lighting Solutions
Kroon Professional Lighting Solutions
Parabool 100
3364 DH Sliedrecht
+31 (0) 184-447977 - info@kroon-lights.nl
Dé leverancier voor al uw verlichting en noodverlichting

 

DL constant voltage 12/24V

DL constant voltage 12/24V
Advies nodig over DL constant voltage 12/24V?
  • Neem contact op met onze afdeling verkoop
  •  
  •  
Of bel: +31 (0) 184 - 447977
Productbeschrijving
  • Light dimming for Voltage 12-24V LED Driver
  • Five distinct modes of operation selected via the dip-switches (are alternatives to each other): 1) On/Off (just On/Off); 2) Push dimming (slow, fast profile, up/down; 3) DALI; 4) Dimming 0-10V; 5) Dimming 1-10V.
  • Dimming Time (0-100 %, 100-0 %): A = 10 seconds, B = 5 seconds;
  • Restart after a power failure, resumption of the last set point;
  • Low level in Push is different from 0 to distinguish it from OFF.
  • Push Dimming: Setting slow (set via DIP): each time dimming continues up to the maximum (or minimum) and then reverses. Time from minimum to maximum, 10secs; Setting fast (set via DIP): each time the dimming continues up to the maximum (or minimum) and then reverses . Time from minimum to maximum , 5secs ; Setting up/down (set via DIP): each time dimming reaches max or min it reverses its direction. Time from minimum to maximum, 10secs . When there are a number of drivers in parallel in any system it is necessary to carry out an alignment procedure in order to compensate for timing errors.
  • 1-10V or 0-10V (set via DIP): you can use commercially available 1-10V (0- 10V) dimmer s. The LED brightness varies proportionally to the signal sent to the terminal. You can use 100K potentiometers. The variation of the brightness of the LED is proportional or logarithmic, depending on the model of the potentiometer (recommended logarithmic) Using dimmers active and domotic systems (impedance 130K) or passive (Iout max 1,4mA)
  • Slave (set via DIP): you can use DL-D/P as Slave
  • Slave B (only for AL42D/P): you can use DL-D/P as Slave with AL42D/P as Master
  • Available only Slave for signal repeating (DL-S)
  • Complying with EN61347-2-13, EN61347-1, EN62384, EN55015, EN61000-3-2, EN61547

Datasheet (PDF)

Certificering (PDF)

Catalogus Alvit 2018 (PDF)

Vraag direct een offerte aan
Kroon Professional Lighting Solutions
  • Altijd deskundig advies
  • Europese kwalititeit
  • Ruime voorraden
  • Korte levertijden
  • Garantie tot 5 jaar
  • Uitmuntende prijs / kwaliteitsverhouding
Artikel Artikelcode Mains voltageMax output currentAmbient temperature TaMax case temperature on TcWeightterminalCable clamp for cable diameter ØConstant Current / Constant Voltage
DL-D/P DL-D/P 12 - 24V DC12A-25÷ 50° C75°0,05 Kg1 x 2,5mm24...6mmConstant Voltage
DL-S DL-S 12 - 24V DC12A-25÷50° C75°0,05 Kg1 x 2,5mm24...6mm